NINTE Honda Civic 4 Door Sedan 2016-2018 Smoke Tinted JDM Style Window Visor Rain Guard

NINTE Honda Civic 4 Door Sedan 2016-2018 Smoke Tinted JDM Style Window Visor Rain Guard

Product Specification:

Vehicle Fitment Information:

Honda Civic 4 Door Sedan 2016-2018

Important Notice:

Please kindly check your car model and make sure the model fits your vehicle in case of buying the wrong product.

Designed to improve the aesthetics of the car,Anti-scratch function，Redefine style.

This item is the whole set of 100% brand new custom fit vehicle precisely engineered for an exact fit to your vehicle. Standard quality control procedure make sure the quality.

This item is made of Highest Grade ABS material & Carbon Fiber Coating finish will absolutely upgrade your exterior appearance.

Sleek Appearance - Smooth Beveled Edges with Tinted Smoke Finish. Reduce Wind Noise and Sun Glare. Keep the Rain out, and Fresh Air in. Double Side Tape Is Included.

Easy installation, save your precious time and no drilling cutting needed, feel free and enjoy with no burden DIY.

Tips:

These covers are to be installed on top of complete factory standard parts.

Please test the fitting before removing protective film.

Clean the installation area before actually tape on.

INSTALLATION INSTRUCTION:

Step 1: Wash the end of your window visor by car cleaner & water to get rid of any dirt or dust to ensure a better bond.Take a clean microfiber cloth & apply some alcohol to it & wipe down the edge of your window visor  where the actual rain guard will sit. This removes any existing wax so the double-sided tape will stick better.

Step 2: Place the rain guard on the window visor with the correct location. After placing the rain guard where you want it, place several pieces of masking tape around the rain guard to mark its location.Make sure that there is an even gap between the edge of the window visor  & the edge of the rain guard on both sides.

Step 3: After placing the tape, place a couple of pieces tape connecting the of the rain guard directly onto the window visor , then draw a line with a pen or marker going down the length of the tape. Then separate it where the tape meets the rain guard . When you install the rain guard , you will use these markings to line up the rain guard  accordingly.

Step 4: After getting the placement correct, take a hair dryer (or if you're careful a heat gun would work) and warm up the surface of the window visor edge. It does not have to be hot, just warm to the touch. Next use the hair dryer on high heat to heat up the tape, the acrylic based tape will heat up quickly. This step makes the tape more pliable as well as more adhesive.

Step 5: Next, take off the red backing of the double sided tape and CAREFULLY line up one side of the rain guard to the position you marked on the window visor .

Step 6: ONCE THE TAPE MAKES CONTACT WITH THE WINDOW VISOR, IT IS EXTREMELY DIFFICULT TO LIFT BACK UP OR REPOSITION. After you have one side down, slowly make your way down the length of the rain guard by carefully pressing down.

Step 7: After the rain guard is installed, an additional step would be to use masking tape to apply pressure onto the rain guard overnight. This allows the tape to reach its maximum adhesion strength. Note that it is critical that you do not tape from the center of the rain guard to the back of the window visor , You want the edge of the rain guard to stay as planted to the window visor as possible.